Installation Instructions
ScuffBuster protection guards are very simple to install; however,
the following instructions must be strictly followed. Any short
cuts will jeopardize and compromise the full bonding capabilities
of the 3M adhesive.
STEP 1. Before installing your ScuffBuster protector, fiberglass
mold release agents, waxes or contaminants must be removed from
the surface of the boat. This can be done by cleaning with any
number of products such as alcohol, acetone, toluene or xylene.
Do not use paint thinner, lacquer thinner or other petroleum-based
cleaners as they will leave a film, and compromise the bond
to the adhesive. Always be sure to follow the manufacturer's
instructions when using any cleaning agent. To further enhance
the bonding process, lightly etch the area using a mild scotch
brite pad, steel wool pad or light 320 grit sandpaper, followed
by the above mentioned cleaning.
STEP 2. Mark the boat hull area where the front trailer roller
or V stop contacts the boat hull (bow protector*) or the area
where the tie-down buckle rubs against the gel-coat (tie-down
buckle).
STEP 3. Remove the liner off the adhesive and carefully place
the ScuffBuster in position. Firmly apply pressure to
get good contact and activate the adhesive compounds.
*If you are installing the bow protector, place it over the
area you marked and carefully bend the ScuffBuster to fit the
shape and curvature of the boat hull. If your boat has strakes
or chines that meet up to the center of the keel, you can take
a rubber mallet and gently tap the material to form around the
surface, and create a custom fit. Be certain to leave the protective
liner on the ScuffBuster Bow Protector while performing this
task. Once you are satisfied with the contour, remove the liner
and press into place.
CAUTION! When working or bending this product, ALWAYS WEAR GLOVES
to prevent injury to yourself and others. This product can cut
your skin if not handled properly.
|
|
